-12%

SMPS1210-FlyBack 12V/10A Genset Battery Charger


Key Features

  • 100 kHz switchmode architecture
  • Float charging system
  • Constant voltage output
  • Current limited
  • Rugged design for industrial environments
  • Wide operating voltage range
  • Rectifier fail output
  • Boost charge input
  • Short circuit protection
  • Overload protection
  • High-temperature protection
  • Analog output for charge current: 0-10 Volt-DC (0-10 A)
  • Click Here To Download SMPS1210-FlyBack User Manual

 22,000.00  25,000.00

Buy all Datakom products like generator controllers, energy meters,  panel meters,  synchronization controllers, auto mains failures (AMF), auto transfer switches (ATS), generator battery chargers, etc, online in Pakistan. You can buy SMPS1210-FlyBack 12V-10A battery charger online or by visiting Electronic Power House (EPH) and Tetralink Technologies (TLT) in Lahore who are the authorized distributor of Datakom in Pakistan. All original Datakom products are available at very reasonable and best prices in Pakistan.

Features

  • 100 kHz switchmode architecture
  • Float charging system
  • Constant voltage output
  • Current limited
  • Rugged design for industrial environments
  • Wide operating voltage range
  • Rectifier fail output
  • Boost charge input
  • Short circuit protection
  • Overload protection
  • High-temperature protection
  • Analog output for charge current: 0-10 Volt-DC (0-10 A)

Description

DATAKOM SMPS 1210-FLYBACK series are fixed output voltage, current limited lead acid, and Nickel-Cadmium battery chargers specially designed for use in gensets. Thanks to their continuous DC outputs they may also be used in a wide range of industrial applications where DC power is required.
The chargers are designed for permanent connection to genset starter batteries. When the battery voltage is below the float charge level, the charger provides constant current, nearly equal to the rated output current allowing a rapid recovery of the missing charge. When the battery voltage reaches the float level, the charger switches to constant voltage charge mode and maintains the battery fully charged, providing the maximum battery life, without overcharging or gassing. The unit has overload and short circuit protection. This feature makes the units deliver only the rated current during
engine cranking or a short circuit condition. They do not need disconnection during cranking. The high-temperature protection of the unit reduces the output current in case of overheating. Thanks to their high efficiency, the self-heating of the chargers is kept in minimum levels allowing operation in warm environments. The wide input voltage range allows the chargers to be used in most countries. The rectifier fail output is provided as a standard feature. This is a semiconductor output pulling to battery negative when the unit is not operating. Thanks to this output, a rectifier fail signal is provided for the Genset control module which will give an alarm in case of failure. The units provide a “boost charge” input as a standard feature. When this input is pulled to battery negative, the output voltage of the charger will be set to the boost charge voltage. This feature may be used temporarily to improve battery life.

Connection Diagram

Click Here To Download SMPS1210-FlyBack User Manual

Based on 0 reviews

0.0 overall
0
0
0
0
0

Be the first to review “SMPS1210-FlyBack 12V/10A Genset Battery Charger”

There are no reviews yet.

× How can I help you?